Steel Plate Rolling, Fabrication of Pressure Vessel Shells

Select the e-quote icon above to submit your requirements for a quotation.

An Edmonton Exchanger technical sales representative will respond within 24 hours.

Shells are rolled to ASME code specifications and are usually rolled to our own head strappings, however, we will roll to customer supplied strapping dimensions.

Shells can be supplied square cut, or beveled with long seams tack welded, or fully welded circumferential and long seams.

Concentric cones can be rolled up to a thickness of 4" (101.60 mm) and a length of 10'-0" (3,048 mm). Diameters can be from 24" (610 mm) O.D. to 168" (4,267 mm) O.D. They are rolled in one piece with
only one long seam when plate layout allows it.

We can provide the cones square cut, or beveled with long seams tack welded, or fully welded circumferential and long seams. Eccentric cones can be rolled up to a thickness of 1" (25.40 mm) and a height of 48" (1,219 mm).

Components rolled from our plate inventory are accompanied with Mill Test Certificates. In the case of hot rolled items, Furnace Heat Charts can be provided upon request.

Fully welded shells and cones come complete with necessary nondestructive examination and the applicable inspection forms.

Steel Plate Rolling
Our four sets of plate rolls enable us to roll plate into shells, rolled rings, cones (both eccentric and concentric), and repads. These components can be fabricated from our own plate inventory or from customer supplied material.

Dimensional Rolling Capacities
Minimum Diameter: 16" (406 mm) I.D.

Maximum Thickness: cold rolled 4" (101.60 mm), hot rolled 8" (203.20 mm)

Maximum Length: 144" (3,658 mm)

The chart below illustrates variables for guideline purposes. As diameters increase and lengths decrease, thicknesses can exceed those stated.

>> Download Brochure (PDF) Select the e-quote icon above to submit your requirements for a quotation. An Edmonton Exchanger technical sales representative will respond within 24 hours. Shells are rolled to ASME code specifications and are usually rolled to our own head strappings, however, we will roll to customer supplied strapping dimensions. Shells can be supplied square cut, or beveled with long seams tack welded, or fully welded circumferential and long seams. Concentric cones can be rolled up to a thickness of 4" (101.60 mm) and a length of 10'-0" (3,048 mm). Diameters can be from 24" (610 mm) O.D. to 168" (4,267 mm) O.D. They are rolled in one piece with only one long seam when plate layout allows it. We can provide the cones square cut, or beveled with long seams tack welded, or fully welded circumferential and long seams. Eccentric cones can be rolled up to a thickness of 1" (25.40 mm) and a height of 48" (1,219 mm). Components rolled from our plate inventory are accompanied with Mill Test Certificates. In the case of hot rolled items, Furnace Heat Charts can be provided upon request. Fully welded shells and cones come complete with necessary nondestructive examination and the applicable inspection forms. Steel Plate Rolling Our four sets of plate rolls enable us to roll plate into shells, rolled rings, cones (both eccentric and concentric), and repads. These components can be fabricated from our own plate inventory or from customer supplied material. Dimensional Rolling Capacities Minimum Diameter: 16" (406 mm) I.D. Maximum Thickness: cold rolled 4" (101.60 mm), hot rolled 8" (203.20 mm) Maximum Length: 144" (3,658 mm) The chart below illustrates variables for guideline purposes. As diameters increase and lengths decrease, thicknesses can exceed those stated.